Q: What can I do if my transmitter stops working?

A: First check the battery in the transmitter. If the battery is ok then  take out the  battery clean the contacts put it
back if it does not work call auto alarm specialist at 305.387.4365

Q: Where can I buy batteries for my transmitter?

A: The most common place to find batteries for your transmitter is your local auto alarm specialist dealer. Many
electronics stores also carry the correct battery  like office-max , radio-shack

Q: What kind of battery does my transmitter use?

A: Omega transmitters use a GP-23A 12 volt battery and skyteck 2ways pager use AAA battery,                            
or call us we can help you.

Q: How can I get a replacement of additional transmitter?

A: First you must identify the model number or the name of your transmitter. Once you know your transmitter
model number or name call us at 305-387-4354  our mobile service will take you one.

Q: If my alarm is armed or triggered and my transmitter doesn't work, how can I disable
my system so I can drive my car?

A: You need to perform an emergency override. Most Omega, skytek, alarms can be disabled by entering the
vehicle, turning the ignition to the run position, then pressing the alarm's valet switch once (Some skytek alarm
systems 2way pageing system the override swicth is on the antenna (call buttom) hold it for 10sec  The alarm
should disarm. To prevent the alarm from accidentally rearming while the transmitter is inoperable, press and   
hold the valet switch for 10sec  seconds to put the alarm in valet mode. The alarm should respond by chirping
twice and turning on the LED status indicator.

Q: Where is my valet switch?

A: There is no way to be certain because the location of the valet switch was chosen by the installer. It is usually
installed somewhere under the driver's side of the dash. Please refer to the pictures below to identify the type of
valet switch you have.

Q: How can I get an Owner's Manual for my Omega ,skyteck system?

A: Most of our current manuals are available on this site. They are downloadable in PDF format from our           
Manuals download  page. If the manual you need is not available, please request it from our customer service
department. CONTACT US

A: Check the battery in your transmitter. If the battery is draining, it will weaken the signal being sent
to your keyless entry/ security system. If you replace the battery and the problem does not go away,
your system may need to be serviced.

Q: How can I get my system serviced?

A: Consult with your local auto alarm specialist dealer. (305)387-4365 Often times, the problem is
simple and can be easily solved. If the problem turns out to be equipment related we have
life time
, if you are out of state  you can send the equipment (control module w/ transmitter(s)) with a
message describing the problem to:    
                                                                           AUTO ALARM SPECIALIST
777 NW. 72 AVE , SUITE 3033 MIAMI, FL 33126
Frequently Asked Questions